AlmaLinux System Requirements
Before you download an image, check that the machine meets the basics below. Numbers come from the official AlmaLinux installation guide and release notes; they are minimums for installing, not sizing advice for a production workload.
Minimum resources
Section titled “Minimum resources”| Resource | Requirement |
|---|---|
| Memory | minimum 1.5 GB RAM |
| Disk space | 10 GB minimum, 20 GB recommended |
| USB drive for installation media | 8 GB minimum, 12 GB or more recommended |
Size production servers from your workload, not from these minimums.
Supported architectures
Section titled “Supported architectures”The installation guide lists Intel/AMD (x86_64), ARM64 (aarch64), IBM PowerPC (ppc64le) and IBM Z (s390x). The AlmaLinux 10.0 release notes list x86_64, x86_64_v2, aarch64, ppc64le and s390x for version 10.
CPU baseline on x86
Section titled “CPU baseline on x86”- AlmaLinux 10 follows RHEL 10 and ships x86-64-v3 optimized binaries by default. CPUs without x86-64-v3 support are not covered by the default build.
- For older CPUs, AlmaLinux 10 offers a separate x86_64_v2 build. The release notes say it is only suitable when the default package set is enough, or when you can rebuild any additional packages you need.
- AlmaLinux 10 no longer provides 32-bit i686 packages.
Firmware
Section titled “Firmware”The installation guide lists BIOS and UEFI as supported firmware interfaces. It does not state anything about Secure Boot, so check your hardware vendor’s documentation before relying on it.
Media types
Section titled “Media types”The installation guide describes three ISO types: boot, a network installer that downloads packages over the Internet; minimal, a self-contained image for offline installation; and dvd, a full image with nearly all AlmaLinux packages. See Download and verify to get and check the image, then Install quick path.
Check what you have
Section titled “Check what you have”uname -mlscpuuname -m prints the architecture, for example x86_64 or aarch64. lscpu shows the processor model and flags (the same flags are in /proc/cpuinfo); compare them with the published x86-64-v3 requirements, because the default AlmaLinux 10 build targets x86-64-v3.